Aqualease™ 75 /18,14KG

Aqualease™ 75 - Solvent Free, Non-Hazardous

Aqualease 75 is a concentrated emulsion of silicone polymers featuring corrosion protection and improved film formation. This formula is designed to release synthetic and natural rubber, microcellular and solid polyurethane elastomers, and thermoplastic resins.

A thin film of Aqualease 75 provides excellent release, requires little or no mold maintenance, and provides better protection against rust on steel molds. This product is an excellent low cost replacement for organic solvent release agents.

Features:

Water based carrier
Excellent release
Excellent film formation
No build-up
Low toxicity and odor
No volatile organic solvents
Reduced health risks
Low mold maintenance

Application:

Dilute 1 part Aqualease 75 with 4 parts water, and preheat molds to operating temperature.
Spray using an air assisted gun. Always apply a light coating before each molding cycle. Excess water will create surface defects on the molded parts.
Should mold build-up occur, dilute Aqualease 75 blend as above in instruction 1 with an additional part of water.
Aqualease 75 is a stable water emulsion of silicone polymers, but repeated or prolonged freezing may cause separation. Should this occur, mix well before using. This product will freeze at 0°C.

Finishing:

Thorough cleaning of molded parts is required prior to staining, painting or bonding. Clean solvent such as mineral spirits will remove any residual oils on the parts surface. In addition, hot alkaline power wash units will remove the release compounds. For suggested cleaning procedures, consult a technical representative.

Aqualease Appearance Application Solids Viscosity Mold Temperature Mold Types