Winkelmandje tonen (0 Artikel) Uw accountVerlanglijstje tonenNaar de kassa

Silicone Thinner®

Silicone Thinner® is a non-reactive silicone fluid that will lower the mixed viscosity of tin cure (condensation) or platinum cure (addition) silicone rubber products.

  • Mold Max Thinner /500ml

    Mold Max Thinner can be used to lower the viscosity od addition and condensation cure silicones. It also lowers the shore hardness of the finished product.

    23,85 EUR (Prijs exclusief 21% BTW)

  • Mold Max Thinner /3,6kg

    Mold Max Thinner can be used to lower the viscosity od addition and condensation cure silicones. It also lowers the shore hardness of the finished product.

    104,30 EUR (Prijs exclusief 21% BTW)

  • Silicone Thinner 5-gallon pail

    Silicone Thinner 5-gallon pail

    289,15 EUR (Prijs exclusief 21% BTW)

Features

Silicone Thinner® offers the following advantages:

A lower mixed viscosity (A+B) means that the rubber will de-air faster when vacuuming.
Mixed rubber (A+B) will flow better over intricate model detail.
Silicone Thinner® will lower the ultimate shore hardness (durometer) of cured silicone rubber.
Pot life (working time) is increased in proportion to the amount of Silicone Thinner® used.

Disadvantage: Ultimate tear and tensile strength are reduced in proportion to the amount of Silicone Thinner® added, however knotty tear properties of the Mold Max® series rubbers are unaffected.
Instructions

Materials should be stored and used in a warm environment (73° F / 23° C). This material has a limited shelf life and should be used as soon as possible. Wear safety glasses, long sleeves and rubber gloves to minimize contamination risk.

*Silicone Thinner® is added as a percentage of the total Part A+Part B rubber system. An accurate gram scale must be used. Weigh out and pre-mix required amount of Silicone Thinner® with Part A of silicone rubber before adding Part B. Mix all components thoroughly and vacuum as directed on mold rubber technical bulletin.

It is not recommended to exceed 10% by weight of total system (A+B).

Because no two applications are quite the same, a small test application to determine suitability for your project is recommended if performance of this material is in question.

Kieswijzer

Hier vindt u onze produkten gerangschikt naar diverse toepassingsmogelijkheden, zoals: Lifecasting, boetseren, afvormen, gieten, make-up, stuntwerk, dentaalwerk en studie.

Merken Toepassingen Contact Verzending Informatie New In